Owner`s manual

Accessing Main Menu Power on the RPC unit. The following status

menu appears:

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : Off

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

If the status menu fails to appear, ensure the correct cables and adapters

are being used and they are connected properly. Also, verify the serial

communication parameters are correctly configured.

Controlling Receptacles To set or change the status of receptacles,

enter one of the following commands: ON n, OFF n, REBOOT n, where

“n” is the outlet number you wish to send the command. Entering an

outlet number of “0” sends the command to all outlets.

Example: To turn “On” Outlet 3, type ON 3 from the RPC prompt

(RPC >). The RPC responds:

Turn On Outlet 3 (Y/N)?

Responding “Y” for yes turns “On” Outlet 3. Observe the

status of Outlet 3 has changed to On in the status menu:

RPC-2/RPC-2A OPERATIONS & CONFIGURATION

____________________________________________________________