Owner`s manual

IMPORTANT:

Crossed RJ-45 cables are required when modular connectors are used,

as shown in Figures 3 – 5, or to interface the RPC to another BayTech

product with modular connectors, such as the DS-Series data switch.

See the cable diagram on Page 23.

5.0 OPERATION AND CONFIGURATION

The following section, “Operation and Configuration,” provides a detailed

approach to accessing, operating, and configuring the RPC.

NOTE It is important that you type all commands correctly. Any

combination of wrong entries results in an error message. As a result,

you will have to start over from the previous menu.

5.1 RPC-2 AND RPC-2A

5.1.1 EIA-232 SERIAL CONNECTION

RPC-2/RPC-2A

The RPC-2 and RPC-2A have an RJ-45 port for connecting to a local

EIA232 device, such as a computer terminal or external modem. Most

serial computers do not have RJ-45 connections; therefore, an adapter is

provided with this unit to convert from a DE-9 connector to

an RJ-45 connector (BayTech Part No. 9FRJ45PC-1). If you are

connecting to a modem, use a modem adapter (BayTech Part No.

25MRJ45MD-8).

BayTech also manufactures a computer/terminal adapter (BayTech Part

No. 25FRJ45PC-1) for converting from a DB-25 connector to a

RJ-45 connector.

RPC-2/RPC-2A OPERATIONS & CONFIGURATION

____________________________________________________________