Owner`s manual

The installation area should be clean and free of extreme temperatures and

humidity. Allow sufficient space behind the RPC unit for cabling and

receptacle connections.

3.3 SAFETY OPERATIONS

When operating, installing, maintaining, transporting, or storing

equipment, take the following special precautions to avoid the introduction

of hazards.

RPC OWNER’S MANUAL

____________________________________________________________

CAUTION For indoor use only.

NOTE Refer to the National Electrical Code (NEC) for applicable

wiring standards.

1. Be sure to connect this device to a grounded (three-prong)

receptacle. The receptacle must be installed near the equipment

and easily accessible.

2. Do not exceed the AC current rating for the selected model. (See

Appendix B “SPECIFICATIONS” for each RPC model).

3. Although the power switch is turned OFF, the unit is not totally

isolated from the power supply. In order to be absolutely removed

from the power supply, the power supply must be unplugged from

the unit.

IMPORTANT For PERMANENTLY CONNECTED

EQUIPMENT, a readily accessible disconnect device

shall be incorporated in the fixed wiring; for

PLUGGABLE EQUIPMENT, the socket-outlet shall be

installed near the equipment and easily accessible.

4. Do not install near water or expose this unit to moisture.

5. To prevent heat buildup, do not coil the power cord when in use.

6. Avoid the use extension cords.

7. When connecting other equipment to the RPC, remove power from

both units.

8. Do not attempt to make any internal changes to the power source.