Owner`s manual

RPC-3 AND RPC-3A QUICK START

____________________________________________________________

2.3 A QUICK START FOR RPC-3, RPC-3A and

RPC-5

RPC-5 Note: The RPC-3 and RPC-5 are configured in a similar

manner. This quick start will reference the RPC-3 menus. The only

programming differences for the RPC-5 pertain to the number of

receptacles shown in the menus.

NOTE: Inlet #1 supplies power to the logic of the RPC-5, this inlet must

have power for the unit to operate.

LOCAL ACCESS

EIA-232 SERIAL Using the 9FRJ45PC-1 adapter and the

CONNECTION RJ08X007 (8-pin crossed) cable, connect the

serial port of your computer to the RJ-45

port labeled “EIA-232” on the RPC unit.

REMOTE ACCESS

NETWORK PORT Using a straight 10Base-T cable, connect

CONNECTION the port labeled Ethernet on the RPC to the

network hub. Establish a Telnet client

session and login from your workstation.

COMMUNICATIONS Load serial port communications software. Set

SOFTWARE serial communications parameters to 9600

bps, 8 data bits, 1 stop bit, and no parity.