Specifications

BayTech Addendum Publication No. Z140A186
Reference BayTech Manual Publication No. U140E121-03 Page 4 of 10
NOTE: These commands are illustrated using the default port select code ($BT).
DS73 COMMAND SUMMARY
Command Description
$BTm,p<cr> Request to connect to peripheral module "m" port "p". If module m is operating in full duplex mode, full
duplex communication is established when connection is made. Otherwise, the connection is for output only
(from DS73 to the selected module/port).
$BTm<cr> Request to connect to module "m". Upon connection, the DS73 will enter command mode for the selected
module and the selected module will respond to its command set. The selected module may be configured by
sending "$CONFIG<cr>" after the "$BTm<cr>".
$BTI<cr> Receive immediate mode data. This will cause the user to receive messages or data from modules configured to
operate in immediate message mode or immediate data mode.
$BT<cr> Disconnect. Terminates the current operation mode or module/port connection. Network session remains
active.
$BTX<cr> Network disconnect. Terminates the workstation session. Releases all session resources, such as modes or
ports.
$BTRI<cr> Locates the user of the Immediate Receive Mode and terminates the session if found, releasing the mode.
$BTRC<cr> Locates the user of the Command/Configuration mode and terminates the session if found, releasing the mode.
$BTRm,p<cr> Locates the user of m,p (module,port) and terminates the session if found, releasing the port.
m = desired module number (1 to 16), p = desired port number (1 to 4), <cr> = Carriage Return