Installation manual

3 On the injector/ejector lever, turn the captive screw counter-clockwise until the yellow band around
the screw head of is completely visible.
Figure 67: Unlocking a Module
4 Squeeze the release latch on the injector/ejector handle and rotate the handle to the right (away
from the module) to unseat the module from the internal connectors.
Caution
To prevent ESD damage, hold the module by the metal rail and front panel only. Never
touch the components on the PCB or the pins on any of the connectors except those
components listed in this procedure.
Figure 68: Removing a Management Module
5 Slide the module out of the chassis slot.
6 Place the module on an anti-static surface.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 94