Installation manual

2 Align the module blank with the card guides for the open slot on the chassis.
Figure 66: Installing a Module Blank without thumb levers
3 Use a #2 Phillips (cross-head) screwdriver to tighten the captive screws at each end of the module
blank. Tighten the screws of each installed module blank before inserting additional modules or
blanks.
Reseating a Management Module DIMM
If you need to reseat the DIMM, perform the following procedure:
1 Attach the ESD-preventive wrist strap to your bare wrist. If it is not already connected, connect the
metal end to the receptacle between the management module slots.
2 Disconnect network cables from the front of the module.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 93