Installation manual

9 Use a # 2 Phillips screwdriver to lock each handle into place.
When a locking screw is fully tightened, the yellow band around the screw head is completely
hidden.
Caution
Be careful to avoid over-torquing and stripping the screw heads.
Figure 63: Locking the Module into Place
Installing I/O Module Blanks
Switches are shipped with a reinforcement shipping cover installed over all the I/O module slots. You
need a #2 Phillips (cross-head) screwdriver to install a module blank. If you have the old I/O module
blanks without thumb levers, see Installing I/O Module Blanks (Without Thumb Levers) on page 92.
After you have installed all the I/O modules for your system configuration, you must install module
blanks in all remaining unoccupied slots.
Caution
All unoccupied slots in a BlackDiamond X series series switch must have module blanks
correctly installed to ensure conformance to FCC requirements as well as to maintain
adequate airflow through the switch.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 90