Installation manual

6 Verify that the module injector/ejector handles are open. Keep the injector/ejector handles in the
open position as you slide the module into the chassis slot.
Figure 62: Installing an I/O Module
Note
If the injector/ejector handles are in the latched position, they prevent the module from
sliding all the way into the slot.
7 Carefully slide the module into the slot until the injector/ejector handles engage the edges of the
chassis and begin to rotate toward the center of the module.
8 Push the handles toward each other to seat the module internal connectors.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 89