Installation manual

4 On each injector/ejector lever, turn the captive screw counter-clockwise until the yellow band
around the screw head of is completely visible.
Figure 60: Unlocking a Module
5 Squeeze the release latch on each injector/ejector handle and rotate both handles outward to
disconnect the internal module connectors.
Figure 61: Removing an I/O Module
6 Slide the module out of the chassis slot.
7 Immediately place the module into an anti-static bag to protect it from potential ESD damage.
The bag will also prevent dust from collecting on the module connectors.
8 If you are not going to install a replacement module, install a blank front panel. See Installing I/O
Module Blanks on page 67.
Installing an I/O Module
You need the following tools and equipment to install an I/O module:
•
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
Module blank panel if you are not replacing the module
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 87