Installation manual

5 Use a # 2 Phillips screwdriver to lock the handle into place.
When the locking screw is fully tightened, the yellow band around the screw head is completely
hidden.
Caution
Be careful to avoid over-torquing and stripping the screw head.
Figure 59: Locking the Module into Place
Installing a Management Module Blank
Install a blank management module in every unoccupied management slot.
If a management module is not installed in a slot, you must install a blank cover over the slot to
maintain proper EMI levels and ventilation to ensure conformance to FCC requirements as well as to
maintain adequate airflow through the switch.
1 Set the blank in place over the open slot.
2 Align and tighten the captive retaining screws.
Removing an I/O Module
You need the following tools and equipment to remove an I/O module:
•
ESD-preventive wrist strap
•
#2 Phillips (cross-head) screwdriver
•
Module blank panel if you are not replacing the module
1 Attach the ESD-preventive wrist strap to your bare wrist.
2 If it is not already connected, connect the metal end to the receptacle between the management
module slots.
3 Disconnect network cables from the front of the module.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 86