Installation manual

4 On the injector/ejector lever, turn the captive screw counter-clockwise until the yellow band around
the screw head of is completely visible.
Figure 56: Unlocking a Module
5 Squeeze the release latch on the injector/ejector handle and rotate the handle to the right (away
from the module) to unseat the module from the internal connectors.
Figure 57: Removing a Management Module
6 Slide the module out of the chassis slot.
7 Immediately place the module into an anti-static bag to protect it from potential ESD damage.
The bag will also prevent dust from collecting on the module connectors.
8 If you are not going to install a replacement module, install a blank front panel. For more
information, see Installing a Management Module Blank on page 61.
Installing a Management Module
Replace an old management module with a new one.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 84