Installation manual

b Align and tighten the retaining screws.
Figure 55: Installing a Fan Tray
Replacing a Management Module
You need the following tools and equipment to replace a management module:
•
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
Module blank panel if you are not replacing the module
1 Attach the ESD-preventive wrist strap to your bare wrist.
2 If it is not already connected, connect the metal end to the receptacle between the management
module slots.
3 Disconnect network cables from the front of the module.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 83