Installation manual

5 Align and tighten the retaining screws.
Figure 49: Installing a Fan Tray
Replacing a Fabric Module
You need a the following tools to replace a fabric module:
•
ESD-preventive wrist strap
•
#2 Phillips (cross-head) screwdriver for the retaining screws on the fan tray
•
5/16-inch flat-tip screwdriver for the retaining screws on the fabric module
You can replace a fabric module without powering down the switch.
Caution
If a fabric module is to be replaced while the BlackDiamond X series is operating, the new
fabric module should be ready to insert. Insert the replacement and replace the fan tray
within five minutes to insure the BlackDiamond X series does not overheat.
1 Attach the ESD-preventive wrist strap to your bare wrist.
2 If it is not already connected, connect the metal end to the receptacle at the right of the power input
connectors.
3 Remove the fan tray in front of the faulty fabric module.
a Loosen the captive retaining screws at the top and bottom of the fan tray.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 77