Installation manual

7 Rotate the lever toward the front of the power supply to fully seat the power supply in the chassis.
8 Replace the power supply ventilation cover.
a Set the lower edge of the cover in place so that the tabs on the edge fit into the matching slots
in the chassis frame.
b Rotate the top of the cover into place against the front of the chassis frame.
c Align and tighten the retaining screws.
Figure 47: Installing the Power Supply Ventilation Cover
Replacing a Fan Tray
You need a #2 Phillips screwdriver to replace a fan tray. You can replace a fan tray without powering
down the switch.
1 Completely loosen the retaining screws at the top and bottom of the fan tray.
Maintaining the BlackDiamond X series
BlackDiamond X Series Switches Hardware Installation Manual 75