Installation manual

4 Verify that the module injector/ejector handles are open.
Keep the injector/ejector handles in the open position as you slide the module into the chassis slot.
Figure 39: Installing an I/O Module
Note
If the injector/ejector handles are in the latched position, they prevent the module from
sliding all the way into the slot.
5 Carefully slide the module into the slot until the injector/ejector handles engage the edges of the
chassis and begin to rotate toward the center of the module.
6 Push the handles toward each other to seat the module internal connectors.
Installing BlackDiamond X series Series Modules
BlackDiamond X Series Switches Hardware Installation Manual 66