Installation manual

3 Using four rack mounting screws, attach the support bracket to the equipment rack immediately
below the intended chassis location.
Screws are not provided.
To provide wider support for the chassis as you install it, you can attach the second support bracket
on the other side of the rack post.
Figure 24: Attaching the Support Bracket
4 If necessary, attach the lifting handles to each side of the chassis.
5 From the front of the rack, lift the back of the empty chassis onto the support bracket.
6 If attached, remove the lifting handles from both sides of the chassis.
7 Slowly guide the chassis into the equipment rack until the mounting brackets are flush against the
rack uprights.
8 Secure the chassis to the equipment rack using six rack mounting screws.
Screws are not provided.
Installing a BlackDiamond X series Series Chassis
BlackDiamond X Series Switches Hardware Installation Manual 52