Installation manual

To enable 10G port speeds with a breakout cable, use the following command:
configure port <port number> partition 10x10G
For specific port configuration commands, refer to the ExtremeXOS Command Reference Guide .
The BDXB-100G4X-XL module has the following LEDs:
•
Module status (STAT)
•
Module diagnostics (DIAG)
•
Port status
When a port is operating in 100-Gbps mode, the farthest left LED below that port lights white to
indicate the 100-Gbps operation. When a port is operating in 10-Gbps mode, each LED for an active
channel from the port lights green
For information about the LEDs and their activity on the BDXB-100G4X-XL modules, see I/O Module
LEDs on page 25.
I/O Module LEDs
LEDs on the front panel of the BlackDiamond X series series I/O modules provide information about the
operating status of the module and ports.
Table 5: LEDs on the BlackDiamond X series Series I/O Modules
Module STAT
Module status
Green/blinking Normal operation.
Amber/blinking Configuration error, code
version error, diagnostic
failure, or other severe
module error.
Off The module is not
receiving power.
DIAG
Module diagnostics
Amber/blinking Diagnostic tests are in
progress.
Amber/steady A diagnostic failure has
occurred.
Off Normal operation.
10G Ports Port status Green/steady Link is up.
Green/blinking Port is disabled.
Amber blinking Packet activity on port.
Off Link is down.
BlackDiamond X series Series Modules and Fans
BlackDiamond X Series Switches Hardware Installation Manual 25