Installation manual

1 = 10-gigabit Ethernet ports 2 = LEDs

In the default configuration for the BDXA-10G48T module, all ports:

•

Are added to the default VLAN as untagged.

•

Inherit the properties of the default VLAN (for example, protocol type and VLAN ID).

The BDXA-10G48T module has the following LEDs:

•

Module status (STAT)

•

Module diagnostics (DIAG)

•

Port status

For information about the LEDs and their activity on the BDXA-10G48T modules, see I/O Module LEDs

on page 25.

BDXB-100G4X I/O Module

The BDXB-100G4X I/O module supports four CFP2 based 100-gigabit Ethernet ports. With appropriate

cabling, each of these four ports can be divided into 10, 10-gigabit data channels.

Note

Note: BDX8 I/O modules are supplied with no pre-installed optical modules.

When the ports are operating in 100-Gbps mode, the port numbers increment by 10. For example, the

first four ports would be numbered (from left to right) 1, 11,21, and 31. Other port numbers are displayed

in ExtremeXOS as “not available.”

When a port is configured to operate in 10-Gbps mode, all ten port numbers associated with that

physical port are displayed as being available. The default mode for the ports is 100-Gbps operation..

1 2 3 4 5 6 7 8 9 10

Green: 10G mode

White: 100G mode

11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Figure 8: BDXB-100G4X I/O Module

1 = 100-gigabit Ethernet ports

2 = LEDs

In the default configuration for the BDXB-100G4X module, all ports:

•

Are added to the default VLAN as untagged.

•

Inherit the properties of the default VLAN (for example, protocol type and VLAN ID).

To enable 10G port speeds with a breakout cable, use the following command:

configure port <port number> partition 10x10G

BlackDiamond X series Series Modules and Fans

BlackDiamond X Series Switches Hardware Installation Manual 23