Installation guide

Replacing a DC Power Supply in the E4G-400 Router
E4G Series Routers Hardware Installation Guide
79
Installing the Replacement Power Supply
To install a power supply:
1 If necessary, remove a blank panel (Figure 52).
Figure 52: Removing a Blank Panel
2 Slide the power supply into the router while verifying that the power supply is right side up (see
Figure 53 and Figure 54).
3 Carefully slide the power supply all the way into the power supply bay (see Figure 53 and
Figure 54). Push the power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
Figure 53: Installing a Summit 300 W DC
Power Supply (Model 10934)
Figure 54: Installing a Summit 300 W DC
Power Supply (Model 10933)
SH_207
SH_208