Installation guide

Chapter 3: Installing an E4G Series Router
E4G Series Routers Hardware Installation Guide
70
Figure 46: MRJ21-to-RJ-48 Fan-out Cable
To connect the cable:
1 Align the cable connector with the port connector and firmly press the cable connector into place
(Figure 47).
2 Use a small straight-tip screwdriver to align and tighten the retaining screw at each end of the cable
connector.
Figure 47: Connecting a Cable to the E4G-B16T1E1 Module
NOTE
Although shielded cables are used in most central office applications, Extreme Networks E4G routers do
not require shielded cables to comply with emissions and immunity requirements.
CSR_036
CSR_027