Installation guide

Installing the E4G-400 Cell Site Aggregation Router
E4G Series Routers Hardware Installation Guide
61
To prepare the DC cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal (Figure 34) and crimp the
terminal securely to the wire.
Be sure to attach the ring terminal to the green/yellow wire.
Figure 34: Attaching Terminals to Cables
Installing the DC Power Supply
To install a power supply:
1 If necessary, remove a blank panel (Figure 35).
Figure 35: Removing a Blank Panel
2 Slide the power supply into the router while verifying that the power supply is right side up (see
Figure 36 and Figure 37).
3 Carefully slide the power supply all the way into the power supply bay (see Figure 36 and
Figure 37). Push the power supply in until the latch snaps into place.
SH_109
Power connection wire
Ground wire
SH_207