Installation guide

Installing the E4G-400 Cell Site Aggregation Router
E4G Series Routers Hardware Installation Guide
59
Installing an AC Power Supply
WARNING!
To prevent an electrical hazard, make sure that the AC power cord is not connected to the power supply
before you install the power supply in the power supply bay.
CAUTION
Make sure that the AC power supply circuit is not overloaded. Use proper over-current protection, such as
a circuit-breaker, to prevent over-current conditions.
To install an AC power supply:
1 If necessary, remove a blank panel (Figure 32).
Figure 32: Removing a Blank Panel
2 Slide the power supply into the router (Figure 33).
Figure 33: Installing an AC Power Supply
SH_201
SH_202