Installation guide

Installing the E4G-200 Series Cell Site Routers

E4G Series Routers Hardware Installation Guide

Installing and Connecting a Clock Module

You can install or remove a clock module in the E4G-200 series router without powering down the

router; however, you must reboot the router to initialize a newly installed clock module.

To install a clock module:

1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate

ground point on the rack.

2 On the front panel of the E4G-200 series router, remove the cover from the clock module slot

(Figure 23).

Figure 23: Clock Module Slot Cover

3 Carefully slide the clock module all the way into the slot (Figure 24).

4 Align and securely tighten the captive retaining screws.

Figure 24: Installing a Clock Module

5 To initialize the clock module, reboot the router.

Save the cover for later re-use in case you must remove the clock module and do not have a

replacement module. An unoccupied module slot must be covered to ensure satisfactory EMI levels and

to maintain adequate airflow through the router.

CSR_010

CSR_011