Installation guide

Chapter 3: Installing an E4G Series Router
E4G Series Routers Hardware Installation Guide
52
Connecting the Router to DC Power
Before you connect the DC input cable to the power input socket on the router, the DC input cable must
be properly connected to the DC source voltage at your facility by a qualified electrician.
CAUTION
Connect the DC input cable to a DC main circuit breaker rated no greater than 15 A.
Provide proper connection and strain relief on the DC input cable in accordance with all local and national
electrical codes.
To connect the router to DC power:
1 Verify that the DC circuit is de-energized.
2 Align the power cable connector with the power input connector on the router (Figure 22) and press
the connector firmly into place.
3 Align and securely tighten the retaining screws on the connector.
CAUTION
Make sure the retaining screws are securely tightened to prevent accidental removal of the
power connector.
Figure 22: Connecting the DC Input Cable
4 Energize the DC circuit.
CSR_019