Installation guide

Installing the E4G-200 Series Cell Site Routers
E4G Series Routers Hardware Installation Guide
51
Preparing the DC Power Input Cable
To prepare the DC power input cable:
1 Strip 0.25 inch (6.35 mm) from the ends of two lengths of #14 AWG copper wire.
2 On the provided connector, identify the positions where you will attach the wires. (See Table 11
and Figure 21.)
Figure 21: Preparing a DC Power Cable
3 Insert each stripped wire into the connector.
Make sure that no exposed part of the copper wire extends beyond either side of the connector.
4 Tighten each retaining screw to 4.5 pound-inches (0.5 Newton-meters) to fasten the wire in place.
Table 11: Wire Positions in the DC Connector
DC
Power Source
–
Connection
+
Connection
–48 V DC -48V 48 RTN
+24V DC -24V +24V
CSR_018