Installation guide

Chapter 1: About the E4G Series Routers
E4G Series Routers Hardware Installation Guide
24
Power Supplies for the E4G-400
The E4G-400 router is compatible with the following power supplies:
300W AC power supply (model number 10930A)
300W DC power supply (model number 10934A)
300W DC Power supply (model number 10933)
An E4G-400 router accommodates one or two 300 W power supplies. You can combine AC and DC
power supplies in the same E4G-400 router. In a redundant power configuration, both power supplies
are fully fault-tolerant and load-sharing. You can remove one power supply without interrupting
router operation.
NOTE
An AC power input cord is not provided with a 300 W AC power supply. You can order an appropriate cord
from Extreme Networks or from your local supplier. The power cord must meet the requirements listed in “Power
Supplies for the E4G-400 Router” on page 123.
The 300 W AC power supply model 10930A has the status LEDs listed in Table 6.
The 300 W DC power supply (models 10934A and 10933) has the status LEDs listed in Table 7.
NOTE
The model 10933 is the recommended DC power supply
Table 6: 300 W AC Power Supply LEDs
LED Label and Color
Meaning
AC IN
OK
Green
DC Out
OK
Green/red bicolor
Off Off No AC input power
Off Steady red No AC input power; receiving standby output from system.
On Off AC input good; 12 V output is disabled. Standby output is ON.
On Steady red AC input good; fault in 12 V output.
On Flashing green and
red
AC input good, 12 V output good.
Power supply alert: power supply is likely to fail because of a developing fault,
such as abnormal thermal conditions or poor fan performance.
On Steady green AC input good; DC outputs good.