Installation guide

E4G-200 Series Connector Pinouts
E4G Series Routers Hardware Installation Guide
127
Table 19 shows the pinouts for the RJ-45 connector on the E4G-200 series clock module.
Figure 71 shows the mini-BNC connectors on the E4G-200 Series clock module, and Table 20 shows the
signal descriptions for these connectors.
Figure 71: Mini-BNC Connectors on the E4G-200 Series CLK Module
Table 21 shows the pinouts for the RJ-48 connectors on the E4G-200 Series F16T1E1 module.
Table 19: E4G-200 Series Clock Module RJ-45 Connector
Pin Description Direction Comment
1 BITS_IN_P In 1.544 MHz, 2.048 MHz RS-422
2 BITS_IN_N In 1.544 MHz, 2.048 MHz RS-422
3 1_PPS_P Out 1 PPS RS-422
4— —
5— —
6 1_PPS_N Out 1 PPS RS-422
7 ToD_N I/O RS-422
8 ToD_P I/O RS-422
Table 20: Signals for the E4G-200 Series Mini-BNC Connectors
Connector
Position
Label
IN OUT
Upper 1 PPS input, 3.3 V level 1 PPS/8 KHz frame output, 3.3 V level
Lower 10-Mhz clock input, 3.3 V level 1.5 MHz/2 MHz/10 MHz clock output, 3.3 V level
Table 21: Pinouts for the E4G-200 Series F16T1E1 Module
Pin Description
1 RX_RING
2RX_TIP
3—
4 TX_RING
5TX_TIP
6—
7—
8—
1 32