Installation guide

2-33
Chapter 2 Installing the Model 5399 Remote Access Concentrator Module
Nortel Networks 5399 Access Switch Hardware Installation Guide
Installing to and Loading from a UNIX Host
This section contains a description of what you need to do to install the
Remote Access Concentrator module’s operational software and image
to a UNIX host. See the Remote Annex Administrator’s Guide for UNIX
for more details.
1. Install the image on a UNIX host. The software installation
notes describe how to do this.
2. Execute the ROM Monitor addr command:
• Enter the module’s Internet address.
• Modify any other parameters that the Remote Access
Concentrator may require for the initial boot, i.e., the
preferred load host’s Internet address and the subnet
mask (see “
addr”onpage3-4).
3. Execute the boot command.
After successful execution of the boot command, the module is
up and running (see “
boot”onpage3-8).
If you have a configured BOOTP server, boot the
Remote Access Concentrator module. Otherwise,
continue to the next step.