Installation guide

2-31
Chapter 2 Installing the Model 5399 Remote Access Concentrator Module
Nortel Networks 5399 Access Switch Hardware Installation Guide
Self-booting the Remote Access Concentrator
The Remote Access Concentrator comes equipped with Flash memory
that contains an operational image you can use to self-boot the module.
To self-boot your Remote Access Concentrator, perform the following
steps:
1. Initialize the IP address parameters using the manual
initialize method.
The manual initialization method is described in “
Manually
Initializing the IP Address Parameters”onpage2-26.
2. Enter the sequence command at the monitor prompt.
The following prompt is displayed:
Enter interface sequence [net]::
3. Enter self, net as the sequence.
The monitor prompt is displayed.
4. Enter the boot command at the monitor prompt.
The display looks similar to this:
monitor:: boot
Waiting for CMB Config Block Info...
Requesting default boot file “OPER_64_ENET.SYS” for
MOP/VMS\ loads and “oper.64.enet” for all other
protocols. Unanswered requests shown as ‘?’,
transmission errors as ‘*’.
Booting file: “OPER_64_ENET.SYS” from SELF
Loading image from SELF ...
.................................................
Load Completed
The self-boot takes 10 seconds to complete. Once the Remote
Access Concentrator has booted, Monitor Mode is no longer
active.