Installation guide

2-1Nortel Networks 5399 Access Switch Hardware Installation Guide
Chapter 2
Installing the Model 5399
Remote Access Concentrator
Module
Thischapterdescribeshowto installyourModel5399 RemoteAccess
Concentrator Module hardware and software, and connect it to a System
5000 Hub. This chapter provides the following information:
• Before You Begin
• Installing the Model 5399
• Testing the Installation
• Connecting a WAN Interface
• Connecting a Service Port Terminal
• Initial Setup and Using the ROM Monitor
• Auto-initializing the ROMs
• Installing the Software and Loading the Operational Image
• Self-booting the Model 5399
• Invoking the Console Monitor
Before you Begin
To successfully install the Model 5399, you need:
• A 3/16-inch flat-tip screwdriver
• An antistatic mat and wrist strap (attached to an antistatic
leash)
• A service port terminal and cable
• A valid IP address