Technical data

Quick-Starting Routers
5-6
117342-B Rev. 00
3.
Start BCC configuration mode by entering
config
at the bcc> prompt.
bcc> config
box#
4.
Check the board configuration inside the router:
box# show config
box type freln
(BLN router with a FRE controller)
board slot 1
type srml
(system resource module in slot 1)
back
board slot 2
type qenf
(Quad Synchronous link module in slot 2)
back
board slot 3
type wffddi2m
(Multimode FDDI link module in slot 3)
back
board slot 4
type sync (
Synchronous link module in slot 4)
back
board slot 5
type dtok
(Dual token ring link module in slot 5)
back
back
console portnum 1
(Console connected to port 1)
prompt {[%slot%:1]$ }
auto-manager-script automgr.bat
auto-user-script autouser.bat
back
back
5.
Configure a port on the router for the initial interface by adding an
interface type of Ethernet on a slot with an appropriate board and adding
its first connector:
box# ethernet slot < number> connector < number>
Use the slot and connector number for your router. For example, enter:
ethernet slot 2 connector 1