Technical data

Using the BCC to Quick-Start a Router
117342-B Rev. 00
5-5
Quick-Starting Your Router with the BCC
The following procedure provides a sequence of commands you can use to
quick-start your BN or AN router on an Ethernet network. Before beginning this
procedure you need to:
• Learn the basic BCC commands listed in Table 5-1
.
• Complete the steps in Chapter 2, “
Preparing the Router for Quick-Start,”
including booting the router with the ti.cfg file.
• For ANs, review the local boot procedure and slot and connector information
in Configuring BayStack Remote Access. By default, the AN router is
configured to boot over the network. To quick-start an AN with the BCC, you
must first change the default boot to local mode with the
bconfig config local
command.
To quick-start your router:
1.
Log on to the Technician Interface as Manager.
Login: Manager
Mounting new volume...
Device label:
Directory: 2:
New Present Working Directory: 2:
Welcome to the Backbone Technician Interface
2.
Start the BCC interface by entering
bcc
.
[2:1]$
bcc
Welcome to Bay Command Console!
* To enter configuration mode, type config
* To list all system commands, type ?
* To exit the BCC, type exit
bcc>