Technical data

Quick-Starting Routers
4-2
117342-B Rev. 00
Before you start the script, review Table 4-1 for the commands you use to run the
script.
After booting the router with the ti.cfg file and establishing a new Technician
Interface session, you are ready to run the install.bat installation script.
To run the script:
1.
Access the volume where the installation files reside by entering:
cd
<volume_number>
:
Include the colon (:) after the volume number.
For example, enter
cd 2:
2.
Start the installation script by entering:
run install
Many steps in the installation script provide default values you should accept.
Some steps are optional for your network requirements.
Refer to your Quick-Start worksheet (see Chapter 3
) as you respond to the
prompts.
3.
Select a slot and connector on the router.
4.
Configure IP on the interface.
Table 4-1. Installation Script Commands
Script Action Your Input Result
Accept the default value. Press Return. Accept the default value the script displays
in brackets, for example,
[E21]
.
Repeat a step to make a
correction.
Press Control-C. The script displays this prompt:
Terminate script y/n?
Enter
n
to continue the script and reenter
the current step by deleting the information
you added for that step.
Press Control-C. The script displays this prompt:
Terminate script y/n?
Enter
y
to terminate the script and return to
the Technician Interface prompt. Before
rerunning the Quick-Start installation script,
reboot the router using the
ti.cfg file.