Technical data

Quick-Starting Routers
3-12
117342-B Rev. 00
Using the Quick-Start Worksheet for WAN Protocols
Use the Quick-Start Worksheet for WAN Protocols (Ta b le 3-3) to record the
information you will need to enable frame relay, PPP, or SMDS using the
installation script. (Using the script to enable WAN protocols is recommended for
experienced users only.) Normally you implement these protocols using Site
Manager or another configuration tool. The script prompts for a WAN protocol if
you select a connector that supports WAN protocols, for example, synchronous.
For more information about the WAN protocol parameters, see these guides:
• Configuring Frame Relay Services
• Configuring PPP Services
• Configuring SMDS
Table 3-3. Quick-Start Worksheet for WAN Protocols
Network Information Example Your Information
WAN Information
Advanced users can use the Quick-Start script to initially configure frame relay, PPP, or SMDS. See the
configuration guides for more information about the parameters.
Frame Relay Information
(To enable frame relay on a synchronous connector on this initial IP interface)
Enable frame relay on the interface? Yes
Management protocol that communicates with the
frame relay network
LMI
DLCI addressing types ADDR Q.922
Frame relay address field length 2 bytes
Frame relay PVC ID 30
(continued)