Technical data

Preparing Your Network Information
117342-B Rev. 00
3-7
Using the Quick-Start ATM Worksheet
The Quick-Start installation script allows you to configure initial routing services
for the ATM Routing Engine link module in Bay Networks routers. You can then
use Site Manager to refine your configuration.
Use the Quick-Start installation script to add ATM to the router by:
• Defining the physical link
• Defining an ATM service record
• Creating an ATM circuit
• Adding the initial virtual circuit to the service record (PVCs only)
• Enabling the IP protocol on the ATM service record
The Quick-Start ATM Worksheet (Table 3-2) contains only the ATM connector,
circuit, and service record information. After you specify the ATM interface, the
Quick-Start script prompts you for the same information found in Table 3-1
,
beginning with the IP Configuration section.
Figure 3-2
shows a sample ATM network used in the examples in the ATM
Quick-Start Worksheet.
See Appendix B, “
Sample ATM Installation Script,” for an example of the script
execution.
For more information about the parameters set in the script, see Configuring ATM
Services.