Technical data

Preparing Your Network Information
117342-B Rev. 00
3-5
RIP Configuration
Should RIP listen to the default route to the network or
subnet where the workstation is located?
Ye s
OSPF Configuration
OSPF router IP address (if different from this interface) 192.32.156.7
OSPF area address 0.0.0.0
Should you enable Simple Password Authentication? No
MTU size for OSPF packets (Default, Ethernet Size,
User-defined MTU)
Default
OSPF interface type
(Broadcast, NBMA, Point to Point, Point to MultiPoint)
Note:
If there is an existing OSPF configuration on the
network, you must set matching values for the interface
type, Hello Interval, and Dead Interval.
Broadcast (default)
Hello interval (in seconds) 10 (default)
Router dead interval (in seconds) 40 (default)
Router priority 1 (default)
Poll interval 120 (default)
If you are configuring OSPF neighbors, add the IP
address for each neighbor.
Note:
Neighbors are defined only if the OSPF interface
type is NBMA. Sample format: 192.32.156.8
Static Route Configuration
Destination network 192.32.90.1
Destination network mask 255.255.255.0
Next-hop address that is in the same subnet as the initial
IP interface
192.32.4.99
(continued)
Table 3-1. Quick-Start Worksheet
(continued)
Network Information Example Your Information