Technical data

Quick-Starting Routers

3-4

117342-B Rev. 00

Table 3-1. Quick-Start Worksheet

Network Information Example Your Information

Physical Connector Information

Number of the slot holding the link module for the first

network interface

Note:

For the ASN, also provide the module number (for

example, module 1).

Slot 2

(QE/NF link module)

Number of the connector (port) on the link module Ethernet connector 1

(XCVR1)

Circuit Information

Circuit name (default is provided)

Note:

Substitute circuit information for interfaces other

than Ethernet.

E21

IP Configuration

IP address of this initial interface

(Advanced users only:

install.bat

supports unnumbered

interfaces.)

192.168.125.34

Subnet mask of this initial interface 255.255.255.0

If this interface resides on the same local area network

(LAN) as the workstation you will use to connect to the

router, you have completed the initial IP configuration.

Proceed to add global services.

If the workstation resides on a different network, add an

IP routing protocol first.

IP Routing Protocol Information

Choose an IP routing protocol if the configuration

workstation is located on another network:

•RIP

• OSPF

• Static Route

See the following sections for details on the IP routing

protocol you choose to configure.

RIP

(continued)