Technical data

Quick-Starting Routers
3-2
117342-B Rev. 00
Many BCC commands and installation script prompts provide default values.
Accept the default values unless you have a reason to make a change. You can skip
optional steps and steps that do not apply to your network.
Using the Quick-Start Worksheet
The Quick-Start Worksheet (Table 3-1) provides a summary of the information
you need to complete the Quick-Start procedure. The information can be applied
to either the installation script or BCC commands.
Most customers configure their initial IP interface on Ethernet. The Quick-Start
Worksheet assumes an Ethernet interface in the connector and circuit fields. For
interfaces other than Ethernet, substitute the appropriate connector and circuit
information and complete the rest of the worksheet beginning with the IP
Configuration section.
For other interfaces, see the appropriate configuration guide for more information
about connector and circuit requirements:
• Configuring Ethernet, FDDI, and Token Ring Services
• Configuring WAN Line Services
If you plan to use the Quick-Start procedure to configure an ATM interface, go to
“Using the Quick-Start ATM Worksheet
” on page 3-7. If you plan to use the
Quick-Start procedure to configure an interface (such as synchronous) that
supports a WAN protocol, see “Using the Quick-Start Worksheet for WAN
Protocols” on page 3-12.
Figure 3-1
shows a sample Ethernet network used in the examples in the
Quick-Start Worksheet. See Appendix A, “Sample Installation Script,” for an
example of the script execution.