Technical data

Preparing the Router for Quick-Start
117342-B Rev. 00
2-11
To boot the router using the ti.cfg file:
1.
Enter the following command:
boot
<slot_number>
:
<image_file> <slot_number>
:ti.cfg
<slot_number> identifies the slot where the files reside on the router and
<image_file> is the software image for your router (see Table 2-4).
For example, enter:
boot 2:bn.exe 2:ti.cfg
The router boots and executes its startup procedure.
2.
Establish a new Technician Interface session by entering:
Manager
In Chapter 3, “Preparing Your Network Information,” you will collect and record
the network information needed to complete the Quick-Start procedure.