Technical data

117342-B Rev. 00
B-1
Appendix B
Sample ATM Installation Script
This appendix presents a sample execution of the install.bat script to add an initial
IP router interface to an ATM network using a LANE service type. See Chapter 3
for the Quick-Start ATM Worksheet to prepare your network information. Your
script will vary, depending on your router model, ATM service type, and network
configuration.
-------------------------------------------------------------------------------
Release 12.10
Copyright 1993-1998
-------------------------------------------------------------------------------
Introduction
------------
This part of the Quick-Start procedure configures the initial IP
network interface on the router. You perform this procedure so that
the router can communicate with the network management station.
Each step of this procedure is further described in the Quick-Start Guide.
As you perform the procedure, refer to the Quick-Start Guide for
additional helpful information and examples.
When you are finished with this procedure, the router will be able to
communicate with the network management station over the IP network. You
are then ready to install the network management software, as described
in the Quick-Start Guide.
Each procedure step requires you to do one of the following things:
1. Enter a number that corresponds to a selection.
2. Enter 'y' for Yes; 'n' for No; 'q' for Quit.
3. Enter a word or phrase referred to as a "text string"
4. Enter <Return> to accept default displayed in [].