Technical data

Quick-Starting Routers
A-4
117342-B Rev. 00
Since the router is not on the same network as the Site Manager workstation an IP
Routing Protocol must be configured in order to manage the box remotely
IP Routing Protocol Configuration Menu
--------------------------------------
1. RIP
2. OSPF
3. Static Route to Site Manager.
Enter Routing Protocol Number [1]:
-----------------------------------------------------------------------
RIP Configuration
Default Route
-----------------
RIP will listen to a specific route to the network or subnet where Site Manager
is located. If you also would like RIP to listen to the default route (0.0.0.0)
then answer ’y’ below. The default route is useful when no specific route is
available in the RIP updates received by this router.
Should RIP listen to the default route? (y/n)[n]:
-----------------------------------------------------------------------
RIP Configuration
RIP Version
-----------------
Specify the version of RIP. The default is to run RIP1. RIP2 runs RIP2 without
the automatic aggregation of subnets that RIP1 provides. RIP2_AGGR provides the
automatic aggregation of subnets for RIP2.
1. RIP1
2. RIP2
3. RIP2_AGGR
Enter Routing Protocol Number [1]:
RIP Configuration Complete
-------------------------------------------------------------------------------