Technical data

117342-B Rev. 00
A-1
Appendix A
Sample Installation Script
This appendix presents a sample execution of the install.bat script to add an initial
IP router interface to a network. See Chapter 3 for the Quick-Start Worksheet you
use to prepare network information before running the script. Your script will
vary, depending on your router model and network configuration.
--------------------------------------------------------------------------------
---
Release 12.10
Copyright 1993-1998
--------------------------------------------------------------------------------
---
Introduction
------------
This part of the Quick-Start procedure configures the initial IP network
interface on the router. You perform this procedure so that the router can
communicate with the network management station
Each step of this procedure is further described in the Quick-Start Guide. As you
perform the procedure, refer to the Quick-Start Guide for additional helpful
information and examples.
When you are finished with this procedure, the router will be able to communicate
with the network management station over the IP network. You are then ready to
install the network management software, as described in the Quick-Start Guide.
Each procedure step requires you to do one of the following things:
1. Enter a number that corresponds to a selection.
2. Enter 'y' for Yes; 'n' for No; 'q' for Quit.
3. Enter a word or phrase referred to as a "text string"
4. Enter <Return> to accept default displayed in [].