Installation guide

117236-B Rev. 00 iii
USA Requirements Only
Federal Communications Commission (FCC) Compliance Notice: Radio Fre-
quency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
European Requirements Only
EN 55 022 Statement
This is to certify that the Bay Networks Nautica 200 is shielded against the generation of
radio interference in accordance with the application of Council Directive 89/336/EEC,
Article 4a. Conformity is declared by the application of EN 55 022 Class B (CISPR 22).
EC Declaration of Conformity
This product conforms (or these products conform) to the provisions of Council Directive
89/336/EEC and 73/23/EEC. The Declaration of Conformity is available on the Bay
Networks World Wide Web site at www.baynetworks.com.
Power Supply
The “in-wall” power module supplied with the Nautica 200 must be used to ensure
continued compliance with the applicable regulations. Should a replacement power
module be required, this must be obtained from Bay Networks.