Specifications

Chapter 4: Web-Based Management Interface | 23
Smart Switch Software Manual
These settings control the Static Multicast Group membership of each port for Static
Multicast.
Add a new group
1. Create a new group by selecting "Add a new Group".
2. Provide the VLAN ID and the Static Multicast MAC Address (start with 01:00:5e).
3. Add group members by tagging the port icon.
4. Click "Apply" to make the changes take effect.
Change group membership
1. Select the Group MAC Address.
2. Change Group membership by tagging the port icon.
3. Click "Apply" to make the changes take effect.
Remove an existing group
1. Remove an existing group by selecting the Group MAC Address.
2. Click "Remove Multicast Group" box.
3. Click "Apply" to make the changes take effect.
Switch> Advanced> Port Rate Setting
Port Rate Setting
The page allows you to specify the threshold rate of ingress and egress packets on each
port. If the incoming traffic rate is above the entered value, the packets will be dropped.
1. Select the port that you want to configure.
2. Enter the threshold Rate.
3. Click "Apply".
Switch> Advanced> Storm Control
Storm Control
The Storm Control page allows you to specify the threshold of ingress broadcast or multicast
& broadcast packets on each port. If the incoming traffic rate of specified packet types is
above the entered value, the packets will be dropped.
To configure Storm Control:
1. Select the type of packet that you want to control.
2. Enter the threshold Rate.
3. Click "Apply".