Specifications

Chapter 4: Web-Based Management Interface | 21
Smart Switch Software Manual
Note: The selected trunk port setting must set to the same VLAN group.
Switch> Monitor Page
The Monitor feature allows you to configure any port's incoming and/or outgoing traffic to be
mirrored to a pre-defined sniffer port.
Sniffer Mode:
• .Disable - disable port mirroring globally.
• .RX - mirroring only the ingress traffic to the designated source ports.
• .TX - mirroring only the egress traffic to the designated source ports.
• Both - mirroring both incoming and outgoing traffic on the designated source ports.
• Sniffer Port: Select one from a pull-down menu.
• Source Ports: Select any number of ports to be monitored (mirrored). The ports can not
be the Sniffer port
Switch> Advanced> Jumbo Frame
This page allows you to enable or disable the Jumbo Frame support. Jumbo Frames are not
an approved standard Ethernet frame size, so you will need to ensure that all of your
networking gear can support these non-standard Jumbo Frames to prevent them from being
dropped. By clicking 'Help' button on this page, you can see the maximum frame size the
switch can carry.
Switch> Advanced> Spanning Tree Page
• Fast Link: When a port running the standard Spanning Tree Protocol (STP) is connected,
it will go through the STP negotiation ( listening -> learning -> forwarding or blocking )
before it will be fully available. If a server is trying to access a client through the switch
running the STP negotiation, it will not be able to connect to it immediately. This can be a
problem for some networks. Fastlink mode solves this problem by setting the port directly
to forwarding mode, thus allowing any server access request to be forwarded. Fastlink