Specifications

Chapter 3: Getting Started | 11
Smart Switch Software Manual
For a Network without a DHCP Server
1. Connect your switch to your existing network.
2. Power on your switch by plugging in the power cord.
3. The default IP is 192.168.0.239.
4. Install the SmartControlCenter on your PC.
5. Start the SmartControlCenter utility.
6. Click Discover to find your switch.
7. Click Configure Device.
Figure 3-4: Assigning the switch a static IP address
8. Choose Disable on DHCP.
9. Enter your IP address, Gateway and Subnet. Then, type your password and click Apply.
Make sure your PC and your switch are in the same subnet.
Note: You can always assign a Static IP address to your switch no matter
if your network has a DHCP server or not.
10. Select your switch by clicking on it. Then click Web Browser Access.
11. To manage your switch via your web browser, click Web Browser Access. The main page
below will display. The default password is password.