Technical data

Modifying and Saving Router Configurations
117347-A Rev. A 3-15
Configuring a LAN Protocol for a Circuit
After you add a LAN circuit, the Select Protocols window opens (Figure
3-9).
Figure 3-9. Select Protocols Window
The Select Protocols window varies according to circuit type, displaying only
those protocols that the circuit type supports. In addition, for certain circuit types,
the window allows you to select the protocol prioritization feature (refer to
Configuring Traffic Filters and Protocol Prioritization for instructions).
To select bridging or routing protocols for a circuit:
1. Click on the box to the left of the protocols you want to enable, then click
on OK.
In some cases, the Configuration Manager opens a protocol-specific
configuration window prompting for additional information. You cannot
enable the protocol unless you configure these parameters. For information
about specific protocol parameters, refer to the protocol-specific
documentation. Any parameter that does not require information uses the
default value.
Some protocols (for example, Bridge, VINES, and NetBIOS) require no
additional information to provide default service.