Technical data

Configuring and Managing Routers with Site Manager
B-20 117347-A Rev. A
Parameter: Source Route
Default: PING_NOSOURCEROUTE
Options: PING_NOSOURCEROUTE
| PING_STRICTSOURCEROUTE
| PING_LOOSESOURCEROUTE
Function: Lets you override the routing table and specify the alternate addresses you
want the ping to go through.
Instructions: Choose the default, PING_NOSOURCEROUTE, to use the routing table.
Choose PING_STRICTSOURCEROUTE if you want to specify all the IP
addresses that the ping must go through to reach the destination address.
You must know all of the addresses for strict source routing to work. With
strict source routing, if the ping cannot get from one of the specified
addresses to another, the ping terminates.
Choose PING_LOOSESOURCEROUTE if you want to specify the
addresses that the ping should go through to reach the destination address;
however, the ping might pass through intermediate hops between the
addresses you specify.
If you choose strict or loose source routing, click on Source Route to
specify the routes.
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.13.1.1.12
Parameter: Ping Source Address
Default: 0.0.0.0
Options: Any valid IP address
Function: Specifies the IP address of the source of the ping request.
Instructions: Optionally, enter the IP address you want to use as the source address of
the ping request. This should be the IP address of the outgoing port on the
router.
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.13.1.1.13