Technical data

Configuring and Managing Routers with Site Manager
3-16 117347-A Rev. A
If you select a protocol service, that protocol is enabled. For example, if you
select RIP or OSPF, the Configuration Manager enables IP because RIP and
OSPF are services of IP.
2. Specify the required information in each protocol-specific window that
opens.
3. Click on OK.
After you define all protocols for the circuit, you return to the Configuration
Manager window. The connector is highlighted to indicate that the interface is
configured.
The Configuration Manager then opens the window for the next protocol
enabled on the circuit.
Configuring a WAN Protocol for a Circuit
After you add a WAN circuit, the WAN Protocols window opens (Figure
3-10).
Figure 3-10. WAN Protocols Window